Notice when Replacing cutting fluid

535Hits2013-12-27 09:17:35　Source:korloy

Among various kinds of metal processing fluid, often applied to the cutting fluid, as the processing of cooling and lubrication, anti-rust, cleaning lubricating oil.The cutting fluid is roughly divided into micro emulsion, emulsion and synthetic cutting fluid.When cutting fluid use after period of time, there will be a bad problem, the lubricating oil suggestion: at this time should be considered an oil change or, the author analyzes the reasons of deterioration and take solution.

　　Cutting fluid metamorphism is a due to a variety of additives of abrasion, belongs to the normal metamorphic, another reason is due to improper use of cutting fluid was contaminated by anaerobic bacteria, which accelerated the stink of cutting fluid and metamorphism.

　　Which sides need to nte when replacing cutting fluid ?

　　1. Should clean water tank and water tank, general is to wash first, and then have a certain concentration than cutting fluid solution cleaning, finally let the cutting fluid dispensing rotation in the machine for about 15 minutes;

　　2. Ensure replacement of the same type of cutting fluid, can not arbitrarily change the cutting fluid；

　　3. At the time of preparation of cutting fluid, especially the preparation of the emulsion, the note shall add water first and then will concentrate poured into the water, or in the case of uniform solution has not yet been emulsified, easily affect the functions of cutting fluid。

　　Engineer suggested liquid cycle：

　　1. Summer heat and rainy season, it is recommended that the liquid for a month and a half

　　2.Winter in liquid cycle can reach more than three months.

　　3.Other seasons replaced every two months.